The lie angle adjustment setting of the TaylorMade M6 driver can be done with the help of the 4-degree loft sleeve as mentioned below. TaylorMade M6 driver lie angle adjustment settings
Align the STD LOFT or UPRT marking on the lowermost notch with the LOFT marking on the second notch if you want to square the clubface.Push the clubhead upwards gently and take it off from the shaft.Put the TaylorMade wrench into the screw that you find behind the clubhead and do a few anticlockwise turns so that it gets loose.The steps to adjust the face angle of the M6 driver are given here. The face angle adjustment settings of the TaylorMade M6 driver can be done using the 4-degree loft sleeve or TaylorMade adapter with three notches. TaylorMade M6 driver face angle adjustment settings The same settings can be done for the M6 driver with 9° and 12° lofts and share the same lie angle. The table given below shows the 12 different adjustments supported by the loft sleeve for a TaylorMade M6 driver with 10.5° loft and how they change the loft, lie, face angle as well as the spin rate of the driver. The higher loft settings will assist you in delivering a draw and/or an anti-fade shot. On the other hand, increasing the loft will raise the spin rate as well as ball flight. The lower loft settings can help you hit an anti-draw and/or a fade. If the loft is lowered, the spin rate and ball flight get lowered accordingly. Tighten the screw to secure the clubhead in position by turning the wrench the same number of times to the right.Replace the clubhead taking care to ensure that the arrow mark on the head is aligned with the previous settings.Make the desired settings on the three notches in the shaft and ensure that they are in line with each other.Lift the clubhead upwards and remove it from its position over the shaft.Turn the wrench a few times to the left until the clubhead becomes loose.Insert the TaylorMade wrench into the screw behind the clubhead of the driver.The steps to adjust the TaylorMade M6 driver are given below. You can adjust the loft sleeve in either the STD, LOWER, HIGHER or UPRT position. Using any other wrench can result in damage to the driver. The adjustment must be done using only the torque wrench provided by the manufacturer along with the wrench.
The two drivers share an identical adjustment process. The TaylorMade M6 driver set encompasses two drivers that are the TaylorMade M6 and the TaylorMade M6 D drivers. Each click of this sleeve movement either increases or decreases the loft and lie angle by 0.5° to 0.75° as well as the face angle by 1° to 2° from their previous settings. The TaylorMade 4-degree loft sleeve helps in fine-tuning ball flight through 12 different positions. This driver supports three types of adjustments comprising the loft, face angle and lie that can be done by means of the 4° loft sleeve.
Yes, the TaylorMade M6 driver is adjustable.
How to adjust TaylorMade M6 D driver settings.TaylorMade M6 driver lie angle adjustment settings.TaylorMade M6 driver face angle adjustment settings.Is the TaylorMade M6 driver adjustable?.